Click image to view full size image
Description:
SpecificationsPneumatic squeeze molding machine
1.suitable for complex modeling models
2.moderate pressure, without special
Specifications
Pneumatic squeeze molding machine
1.suitable for complex modeling models
2.moderate pressure, without special requirements
Pneumatic squeeze molding machine
Specification
The machine can be used for a variety of foundry sand down boxmodeling clay, the composition can be used alone or mechanizedassembly line, or be composed of semi-automatic line use.
1. Using pneumatic compaction more contacts, no oil leakagetroubles; moderate pressure, without special requirements on thesand, prodsr''s number are more 48, suitable for complex modelingmodels.
2. The time when the machine in the pressing, rack withoutpower, but by the body over the side of the contact rod hookhanging four tables, and more contact with the down-out, forcompaction, if the contact , hook, sand box, plate, table as asystem, then the strength of this pressure is the internal force,or internal force compaction.
3. Pressure shock real, contact the one hand, sand compaction,while with the Shock with the table (with the rack from the rackwithout vibration). Therefore, effective Shock compaction, sanduniformly high hardness (an average hardness of 85 ~ 90, B-typehardness value), eating sand content can be as small as 20 to 30mm, eating sand ratio up to H: B = 2 ~ 3 , and its vertical planeof the hardness of the cavity can reach more than 80.
4. This machine adopts pneumatic spring fully buffered microinstitutions, so no special requirements on the ground, from themold with rod, synchronizing shaft structure, the oil pressuretiming, synchronization from the mold, good speed control withease.
Pneumatic squeeze molding machine
